#Neo qube black how to#

As far as I remember, the case just has the DRGB strip in the front and it can run on with just SATA power, however there is a cable should you want to control it via MB (but then you lose the pre-set effects and the ability to control it via the front I/O).

#Neo qube black how to#

My case fans/Lian Li's are hooked up to the MB ARGB headers, but they aren't tied in to the front of the case (if they can be, I don't know how to do that). I assumed the RAM/GPU/Cooler couldn't be synced as they are using RAM/PCI slots or are directly connected to a MB fan header (cooler rad fans), so these may need to be customised with software, but I don't know of any software that will do it. How does one achieve this with this case?! Not possible? Do I have to buy a Phanteks DRGB hub or something? I've tried Google and Phanteks website and trying to learn more about RGB/ARGB/DRGB in general, but I'm completely stuck and very new at this.Īny help/advice would be much appreciated! I just want my system to cycle through the 3 tone colour combo, similar to the look on the Metallicgear promo images - where not only are the front panel and fans running what seem to be the same colour combo, the MB/RAM seem to have it as well. To top it off, Mystic Light does not allow you to set custom multi-colours - you can choose a single colour that you can then apply an effect to or have static, but you can't have more than one colour unless you select the standard 'rainbow' option. I have the front strip set to a really nice colour combination using the built-in functions from the mode button on the front and I'd like the rest of the system to reflect that, however as my fans, Lian Li Strimer(s) and then obviously NZXT Cooler/RAM/GPU are all plugged into the MB, I can't get them all on the same lighting effect. I have a new system build in a Metallicgear Neo Qube and I'm wondering how in the world to hook the lighting up so that everything runs off/matches the front panel light strip? Is that even possible?